If the distance A between the insides of the legs is less than 740 mm, move the control box installation position to the left (B=192 mm). Note The thickness of the table should be at least 40 mm, and it should be strong enough to bear the weight and vibration of the sewing machine. Table processing diagram * If using a commercially-available table, process it as shown in the illustration below.
Install the belt cover and the frame side cover to The seģ. Furthermore, do not excessively bend the cable or secure it too firmly Contact your Brother dealer or a qualified staples, otherwise there is the danger that fire or electrician for any electrical work that may need to electric shocks could occur. INSTALLATION CAUTION Machine installation should only be carried out by All cords should be secured at least 25 mm away a qualified technician. For Heavy-weight Materials, Work Clamp Lifter (Pneumatic Type) 2. For special use, Work clamp Lifter (Pneumatic Type) *4 BAS-326F-0 A 1.
For Heavy-weight materials, Work Clamp Lifter (Pneumatic Type) BAS-311F-L A 4. Work Clamp Lifter (Solenoid Type) BAS-311F-0 2. NAME OF MAJOR PARTS (8) (12) (7) (11) (3) (16) (17) (15) (18) (10) (14) (9) (20) (1) (19) (2) (4) (5) 1157S (1) Power switch (2) Control box (3) Operation panel (4) Presser lifter pedal (6) (5) Starting pedal (6) Motor cover (7) Pulley (8) Spool stand (14) Programmer (15) Floppy disk drive (16) Emergency stop swich (17) Thread wiper switch (18) Dip switch (19) Integrater (20) Solenoid valve (13) Safety devices (9) Finger guard (10) Eye guard (11) Thread take-up cover (1Ģ. If the ground connection is not secure, you run a high risk of receivingĬONTENTS 1. 2 1 Safety devices Eye guard High temperature warning display 3 Finger guard Thread take-up cover Belt cover Frame side cover, etc. If the labels have been removed or are difficult to read, please contact your nearest Brother dealer. Please follow the instructions on the labels at all times when using the machine.
Be sure to wear protective goggles when usiģ Warning labels The following warning labels appear on the sewing machine. If the machine is used without these applications other than sewing. Attach all safety devices before using the sewing The sewing machine should not be used for any machine. TemperaĬAUTION Sewing If using a work table which has casters, the casters This sewing machine should only be used by should be secured in such a way so that they operators who have received the necessary cannot move.
CAUTION Environmental requirements Use the sewing machine in an area which is free The ambient temperature should be within the from sources of strong electrical noise such as range of 5 to 35 during use. Touching areas where high voltages are present can result in severe injury. Follow the instructions from training personnel and instructors regarĢ Notes on safety DANGER Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. With industrial sewing machines, it is normal to carry out work while positioned directly in front of moving parts such as the needle and thread take-up lever, and consequently there is always a danger of injury that can be caused by these parts. Before using your new machine, please read the safety instructions below and the explanations given in the instruction manual. Thank you very much for buying a BROTHER sewing machine.
Please keep this manual within easy reach for quick reference. INSTRUCTION MANUAL BAS-311F-0, 311F-L BAS-326F-0 Please read this manual before using the machine.